APPLICATION CONTEXT

Biomass Pellet Production Process

A practical overview of the main equipment stages from raw material preparation to finished pellet handling.

TYPICAL LINE SEQUENCE

From material preparation to finished pellets.

Raw Material IntakeIncoming biomass is received and moved into preprocessing and storage systems.
Chipping / Pre-ProcessingMaterial is prepared for the downstream grinding and drying stages.
Wet GrindingMaterial may be reduced while moisture is still present before drying.
DryingMoisture is reduced to prepare material for fine grinding and pelletizing.
Fine Grinding / Hammer MillingMaterial is ground to a more consistent particle size before pellet formation.
PelletizingPrepared biomass is compressed through the pellet mill to form pellets.
CoolingFresh pellets are cooled and stabilized after compression.
Conveying / Storage / OutloadingFinished pellets are transferred, stored and prepared for shipment.

Typical biomass pellet production flow shown for application context. SXM focuses on selected bearing positions, replacement components and wear parts within the process.

STAGE-BY-STAGE EQUIPMENT OVERVIEW

Where application information matters.

Raw Material Intake

Incoming biomass is received and moved into preprocessing and storage systems.

SXM support

Application context
Material-handling position review

Chipping / Pre-Processing

Material is prepared for the downstream grinding and drying stages.

SXM support

Process-position context
Bearing information review on inquiry

Wet Grinding

Material may be reduced while moisture is still present before drying.

SXM support

Bearing identification
Replacement bearing references
Seals and related components where applicable

Explore Wet Grinder Bearings

Drying

Moisture is reduced to prepare material for fine grinding and pelletizing.

SXM support

Installed-position review
Bearing identification
Replacement discussion based on existing information

Explore Dryer Bearings

Fine Grinding / Hammer Milling

Material is ground to a more consistent particle size before pellet formation.

SXM support

Rotor and drive-position review
Bearing identification
Selected seals and housings where applicable

Explore Hammer Mill Bearings

Pelletizing

Prepared biomass is compressed through the pellet mill to form pellets.

SXM support

Main shaft, roller assembly and drive bearing review
Ring dies
Roller shells and seals

Explore Pellet Mill Bearings

Cooling

Fresh pellets are cooled and stabilized after compression.

SXM support

Selected bearing-position review
Replacement bearing identification
Related components where applicable

Explore Cooler Bearings

Conveying / Storage / Outloading

Finished pellets are transferred, stored and prepared for shipment.

SXM support

Conveyor and support bearing review
Selected housings and related components
Replacement identification support

Explore Conveying & Feeding Bearings

RELATED EQUIPMENT PAGES

Explore the positions that are currently documented.

All equipment

PelletizingPellet Mill Bearings

Cost-effective replacement bearings for selected pellet mill positions.

GrindingWet Grinder Bearings

Bearing selection support for wet grinding positions in pelletizing lines.

GrindingHammer Mill Bearings

Bearing replacement and identification support for hammer mills used in feed and biomass processing.

DryingDryer Bearings

Bearing identification and replacement support for selected biomass dryer positions.

Cooling & ScreeningCooler Bearings

Bearing and replacement support for selected cooler and screening equipment positions.

ConveyingConveying & Feeding Bearings

Bearing support for selected feeding, transfer and conveying positions in biomass pelletizing lines.

RELATED BEARING REFERENCES

Start with a known marking.

Browse bearings

The references below support identification. Final replacement review still depends on the complete designation, installed position and operating conditions.